This article shows how to install your new AI-14 camera into your vehicle. If the camera has been installed into the vehicle and you are looking on how to assign the camera to a vehicle, please select Navistream Camera Management
Initial Assessment
Check the vehicle for any pre-existing electrical problems or damage and report findings to the owner.
Locate the hardwire point for the power cable.
Mounting
Choose a mounting location that does not obstruct your view or interfere with vehicle controls.
Verify the dash cam's view and its ease of removal before marking its final position on the windshield.
Clean the marked area, attach the mount, and allow it to dry.
Device Installation
Turn off the dash cam.
Route the power cable safely from the power source to the mount, hiding it behind the plastic trim.
Plug the power cable into the dash cam.
Place the dash cam on its mounting bracket.
Final Checks
Turn on the dash cam and confirm the live video view is correct.
Tighten all screws and verify that the power cable and dash cam are securely in place.
Ensure the vehicle is operating normally, with no new warnings or changes in performance.
You have successfully installed your new camera into the vehicle, next you will assign a vehicle to the camera using the Navistream Web Portal. For this select Navistream Camera Management.
If you have any questions or issues during installation please contact Navistream Support.
Navistream Support
1(844)571-8200 Ext 2
navistream@stti.ca